I've started a new post as this is a bit different to downloading parameters.
I think I have recovered all the data and parameters and all the screen are there. I'm now looking at saving the 2 tool change macros. One for auto and one manual.
Here is one macro
Code:
09021(MANUAL TOOL CHANGE MACRO)
IF[#1015 EQ 1] GOTO 50; CHECK MACHINE LOCK / Z AXIS LOCK
#1100=1; CHECK M86 COMMAND FORM 09020 SIGNAL
#101 = #4001; MEMORY G CODE
#102 = #4002; MEMORY G CODE
#103 = #4003; MEMORY G CODE
M05; SPINDLE STOP
G17 G91 G80 G0; DEM G STATION
M19; SPINDLE ORIENTATION
M86; ENTER ATC MODE
M07; AIR BLOW
G30 Z0.0; Z AXIS RETURN SECOND POINT
M00; PROGRAM STOP
M07; AIR BLOW
G28 Z0.0; RETURN REF
G#101 G#102 G#103; SET G CODE
#1100 = 0; CANCEL M86 COMMAND FROM 09020 SIGNAL
M87; FINISH TOOL CHANGE
N50 # 3000 = 2 (MACHINE LOCK / Z AXIZ LOCK) ;ALAM MESSAGE
M99;
%
I can't find much on entering or sending macros to the controller.
Any suggestions ?