[kurt_laughton]

i have a hitachi seiki 4NE2-600 w/ a Fanuc gn6 control and a parameters are messed up anyone have parameter list? thanks

[gm3211]

Are you looking for CNC Communication parameters to upload and download?

Greg Mercurio
Shop Floor Automations
www.cncnetworking.com
877.611-5825

[kurt_laughton]

That and all machine parameters. Thanks

[gm3211]

Send me your email address and I will reply back with the parameters for CNC communications....

[email protected]

Subject: Request Fanuc 6 parameters

[kurt_laughton]

i just e-mailed you.

[tbolduc]

Hi all,

Newbe here.

I'm trying to help out a friend with a KIA 4ne2-600 with Fanuc 3tf control that lost all his parameters.

Would any one here have a copy of it?

[tbolduc]

Still have not had any luck with parameters for this machine, any ideas where to go with this? I have had 0 luck with KIA even answering the phone

[tbolduc]

Some one has to still have one somewhere Any suggestions?

[Abdullah]

i have a hitachi seiki 4NE2-600 w/ a Fanuc gn6 control and a parameters are messed up anyone have parameter list? thanks

i have hatachi seiki 4NE-2 i had a problem with spindle my spindle rpms are too low. i gave him the command to run 3000 rpm but machine runs only 300 rpms

[tbolduc]

i have hatachi seiki 4NE-2 i had a problem with spindle my spindle rpms are too low. i gave him the command to run 3000 rpm but machine runs only 300 rpms

Just a thought does it need a m42 command before the speed command to put it in high gear?

[Abdullah]

Just a thought does it need a m42 command before the speed command to put it in high gear?

its high gear commad is m41 i had found the problem in its PLC micon 8 it didnt generate the voltages. some one provides me hitachi seiki 4ne2 maintince manual.