I am using the Teksoft platform release 14.10B - Is there anyone out there that has a post for an Okuma Mill - OSP-U10M - it is a Crown V-4018 iron
I would be willing to jump through a few hoops for this one -
Bill Hinson
[email protected]
I am using the Teksoft platform release 14.10B - Is there anyone out there that has a post for an Okuma Mill - OSP-U10M - it is a Crown V-4018 iron
I would be willing to jump through a few hoops for this one -
Bill Hinson
[email protected]
i use the same software the you use teksoft procam
i have the okuma ops5000L and 7000l
Hi Buddy ,
I desperately need a Mastercam Post processor for OKUMA Lathe LB3000. Wondering can any one help me in this case?
I will do appreciate for any help or advices. Cheers.