Mactec54,
Back out in the garage tonight to try to figure this thing out after a long trip to South Florida. I tried the last set of parameters. Same results as yesterday, spindle does not run at full speed.
I double checked my wiring, 10V (Red) to the #3 terminal, GND (Blk) to my #1 terminal (Common) and the AI1(White) to the #2 Terminal (Wiper of Pot). What type of volatge should I be getting out the the VFD on the 10V terminal and GND? I have about 0.2V, What volatge should I be getting from the AI1 terminal, I'm getting about the same volts. Should I be checking volts at any other place?
Thanks, Mark