I'm retrofitting a 1999 Fadal 3016L with the following;
-Fadal (analog +-10v) AC drives
-BALDOR wye/delta analog Vector Spindle drive (with encoder for tapping)
-21 tool geneva (non servo) ATC (MOTOR DRIVEN TURRET AND SLIDE)
-PDI Bijur way lube system
-Flood coolant
-Thru tool coolant
-E STOP (contactor type)
-MPG with single ended encoder
Will a KFLOP and KANALOG have the I/O to operate everything on the mill? I'm considering using Mach4 control software.... Is the KFLOP a good pairing with Mach4? Any tips or further information is appreciated.
Chris