[shakoori]

Hi
recently I have got the 109 error on machine I rest the drive unit in machine cabin but again it will come and the machine stops .please help me

[ospcontrol]

H?
WE CAN REPAIR THE DRIVER I CAN HELP YOU
THANKS

[servtech]

Hi
recently I have got the 109 error on machine I rest the drive unit in machine cabin but again it will come and the machine stops .please help me

This is a generic spindle drive fault. If resetting the drive does not clear the fault, please refer to the spindle drive manual.
Post a photo of the drive with error condition LEDs and we might be able to help.

[shakoori]

Thanks for the answer
It gets the OL Alarm or OC alarm . I reset the drive and clear the fault but the machine gets the alarm more than 10 times in a day .

[ospcontrol]

can you tell me please alarm led on driver
VAC D11 UN?T ?

[shakoori]

A technician check the drive and its OK . I suspect about the spindle encoder because I plug out the cable of that and agian plug in so the errors increased I don't know what to do

[ospcontrol]

I can help you with the repair your convenience problem will be solved please contact me

[ospcontrol]

please check your massage box

[shakoori]

My email
[email protected]

[shakoori]

Phone number is not correct. Opscontrol

[servtech]

A technician check the drive and its OK . I suspect about the spindle encoder because I plug out the cable of that and agian plug in so the errors increased I don't know what to do

Unlikely to be the spindle encoder, you would normally get speed difference error on screen. But, see if you can change the spindle speed tolerance to 20% in the parameters, it may help.

[servtech]

Thanks for the answer
It gets the OL Alarm or OC alarm . I reset the drive and clear the fault but the machine gets the alarm more than 10 times in a day .

These errors indicate overload or overcurrent of the drive power supply or transistors. Possibly drive fault or motor windings shorted.

[ospcontrol]

hi
?,m whatsapp
https://wa.me/905308484856

[shakoori]

Motor not shorted transistors are OK.
We changed some capacitors on spindle driver board now the only alarm is OC

[servtech]

Motor not shorted transistors are OK.
We changed some capacitors on spindle driver board now the only alarm is OC

OC usually means overcurrent. So indicates a short or transistor fault.

One time I had an Okuma motor fault where there was a motor connector insulator fault, the crack was between the two thermistor pins and the motor phase pins, power tracked and caused an OC fault and axis noise. Okuma supplied new motor plug and cable connectors, no fault after replacement.

[issa1964]

my milling C.N.C machine had lose ALL PARMETERS , IF possible send to me the parmeters( bridgeport vmc 500 with heidenhain tnc 370 cnc control) Tank tou ,

[shakoori]

Thanks everyone the problem has been solved