I know right? I'm very new to this and still in my builds commissioning stage, so I'm assuming I've cocked something up.
example of my test file (50mm square) below:
%
( File created using Intuwiz Software Service )
(
https://www.intuwiz.com )
( More information:
https://www.intuwiz.com/rectangle.html )
( File created: 2022-03-16 08:54:09 UTC )
G00 X0 Y0 F70
G01 Z-1 F50
G01 X0 Y50 F50
G01 X50 Y50
G01 X50 Y0
G01 X0 Y0
G00 Z0 F100
M30
%
Changing the G1 to G0 works fine.
I tried a simple move in MDI with same results.
'G1 X50 F100' nothing
'G0 X50' works fine
The log for that is
2022-03-16 21:39:08.201 - Logging Enabled.
2022-03-16 21:39:10.821 - API: mcCntlCycleStart(inst = 0) (unknown caller)
2022-03-16 21:39:10.942 - Attempt transition from "Idle" on event "Cycle Start" machapi.cpp:3085
2022-03-16 21:39:10.943 - Transition from "Idle" on event "Cycle Start" was rejected by a guard function! machapi.cpp:3085
As per the OP I'm think its a feedrate issue.