[1ctoolfool]

I'm making a list to print out as a quick reference for the most used parameters and settings that are the most commonly needed,

everyone please contribute the settings and parameters that they access most frequently so I can compile a list.

I'm starting with the following:

Settings
51 - Door feed hold override
10 - Limit 50% rapid
7 - Parameter Lock
92 - OD ID chuck clamp
163 - .1 jog disable

Parameters

?

[gar]

071012-0845 EST USA

1ctoolfool:

A discussion of why and how you want to use this information would be helpful. Following are a few with comments:

51 ON -- disable door interlock -- immeadiately after every power on
7 ON usually -- OFF when needed -- parameter lock
9 INCH always
RS232 stuff
11, 12, 13, 14, 37, 41, 55, 69, 70 -- some moderately often -- testing purposes
15 ON -- H & T code agreement -- always
23 -- 9000 edit selected as needed usually ON meaning inhibit
29 -- G91 non-modal -- never used but might be useful
31 -- reset program pointer -- would this be useful in DNC (drip feed mode) -- I have not used it
33 HAAS -- always set to this mode, on lathe FANUC mode because no HAAS mode
49 ON -- tool change -- always ON
108 -- rotary quick return
109 ZERO -- always -- I do not trust something I have no way of monitoring
143 -- interrogate machine for data while running -- useful if I were to have the function

.

[SeymourDumore]

#32 - Coolant override. During testing to IGNORE. I don't like Dry-Run

[Gtmachine]

there is a complete directory in the control. go to help and punch in the letter D, or what ever code you need to know about

[txcncman]

there is a complete directory in the control. go to help and punch in the letter D, or what ever code you need to know about

6 year old thread. They are listed in the manual too.