Hi guys .,

I have recently purchased CS-D808 drivers and i am getting a bit confused hooking them up.

My plc is 24v and the IO is 24v.

Now my next step right now is to get the alarm and in position connected to my plc.

Now the signal cables are 5v and i can take the 5v from there daisy chaining to both alarm and in position. But when either of those trip ., will they act as a switch ( on/off ) or ?

Cause if the work as a switch then i dont have problem as i know my plc can use that ., but if they dont ., will i then not have to use 24v into the alarm and in position ? and thus getting 24volt out to my plc..

Hope you understand what i mean