Hello
I am using alphacam 2022 standard router.
The version I used does not have a vba editor.
I'm writing a macro with the vba editor in alphaedit, but I can't run it in my alphacam. can you help me on how to get it working?
Hello
I am using alphacam 2022 standard router.
The version I used does not have a vba editor.
I'm writing a macro with the vba editor in alphaedit, but I can't run it in my alphacam. can you help me on how to get it working?
Hi,
I'm afraid that VBA alphaedit compiles code differently than VBA alphacam. However, you can set up a reference to the Alphacam Router and run the code directly in Alphaedit and control Alphacam from Alphaedit.
Alphacam post and VBA macros, Autodesk HSM post.
www.cadcam-softcz.cz
Try check this. https://drive.google.com/drive/folde...usp=share_link
Alphacam post and VBA macros, Autodesk HSM post.
www.cadcam-softcz.cz
Thank you very much. i will try right away
Would it be possible for you to give an example about knife identification?