[Edinei]

FCAM3 monitor não funciona a a unidade indica 4leds vermelho.
Máquina ficou dois meses desligada.
Preciso de manuais tbm do dyna myte 4500 e 4800

[Al_The_Man]

I have Meldas M3 maintenance manual if needed.
If so PM email address.
Al.

[Edinei]

I have Meldas M3 maintenance manual if needed.
If so PM email address.
Al.

[email protected]

Muito obrigado pelos arquivos

- - - Updated - - -

[email protected]

Muito obrigado pelos arquivos

[email protected]

[MrMetric]

You can get quite a few manuals from the Mitsubishi site, actually, which is very nice. However, they are all in English. Given that your post are in some other language (I don't even know which one!), I am not sure this will help you. I would suggest that you use Google translator to make your request so that we can try and help you.

I have a Dyna DM4400m, which also has a Mitsubishi Meldas M3 control. I just turned mine on, and I looked at my LEDs. My board is an MC161-1, which I note that yours is an MC1619-1. I really don't know the difference, but the boards have the same connector and LED layout. When I turn my control on, I get NO red LEDs turned on in the area you have shown. The bottom green LED is steady on, and the green LED above this flickers on/off at a rapid rate (as though it is indicating communication or something).

A common problem with the Meldas M3 control occurs if you have them turned off for a long time or if the battery is weak. This will cause the machine to lose its parameters and you need to perform a system reset. This is detailed in the Dyna forum, but I can dig this up for you if you would like.

The biggest problem right now is there is a large language barrier. Most of this forum communicates in English so you will probably have the best luck if you use Google translator and post in English. Most people are generally very patient, so do not worry if your English is not perfect. We will figure it out. :-)

[9xpro02]

Dear Sir.
Now, I need the Meldas M3 maintenance manual.
Can you help me with your generous.

I am very grateful with your help.
This is my email address: [email protected]

[MrMetric]

I just sent you links for this and the MR-S11 drive maintenance manuals. I'm guessing that you probably are missing that too.

[Davemartinez]

hello

I have a VMC MIGHTY COMET 500. It works quite well for a rather old machine.
either way, the problem is this, the CRT started to go completely orange, I checked the 10 pin cable, I moved some adjustments from the back of the CRT and nothing.

I decided to buy a 9" LCD, just didn't check that the configuration type in mine is BKO-NC6212 MDT962B-1A, and I chose one of the BN0907 MDT962B-1A series.
the difference they have is the graphics card, and its connectors, the one I have is 6-pin and the one it occupies is a 15-pin one. (Attached image).

Does any of you know if it is possible to use it with some adaptation, or if you have an electrical diagram manual, it can also be very useful for me.

I add some images.

the control is a MELDAS M3/L3.

thank you for your time.

DM