Looking for some smart people with experience with the acramatic 2100 control! My machine was sitting idle and then started rotating the turret nonstop on its own. I shut the machine down before I looked at what alarm it through and powered it back up and now I’m getting the cnc engine failure alarm. I’ve read I could have lost settings in the rt bios. Wanted to see if that sounds correct? The pc power supply looked horrible so I went ahead and bought a new one so I’m thinking that may have been what caused the original issue but not 100% sure on that. When I boot the machine now I get the two red leds lit up on the bridge board and get the rt failure alarm. I ordered an isa video card to see if I can get into the bios od the rt board but just wanted to see if I’m on the right track. Thanks!