I know extremely little about control electronics, so maybe this is a dumb question. Is it possible to hook up a MPG to a knee mill with power feed (60v DC servos)? Or do MPGs only work with a CNC controller/servo drives on board? In other words, how hard would it be to setup the wheel seen on most MPG to run a servo motor in steps/continuously?
Results 1 to 6 of 6
Threaded View
-
03-09-2023, 03:03 AM #1
Member
- Join Date
- Nov 2017
- Posts
- 83
Is Running a manual mill/power feed with an MPG possible?
Reply With QuoteSimilar Threads
-
Anyone with a TM or Mini Mill running on single phase power?
By mech1atgsk in forum Haas MillsReplies: 7Last Post: 02-27-2020, 01:09 AM -
Power feed for manual IH
By slatronic in forum Charter Oak Automation Support ForumReplies: 6Last Post: 03-13-2012, 02:55 PM -
Power feed for the PM-30 lv mill?
By gumba in forum Benchtop MachinesReplies: 8Last Post: 07-15-2011, 03:04 PM -
Circuit for running a driver as a power feed?
By Greenbuggy in forum CNC Machine Related ElectronicsReplies: 1Last Post: 02-14-2011, 01:34 AM -
EMCO FB-2 Mill - need power feed?
By brassman1 in forum Benchtop MachinesReplies: 0Last Post: 11-04-2005, 06:18 PM
Tags for this Thread
Posting Permissions
