Hello,

I acquired a durga 25e with the fanuc 0T control and an autobar 400 loader on it. I had some issues getting it up and going. I believe I'm on my last problem to solve: I can't get the spindle to run.

The machine powers up, I initialize the loader, home the lathe, jog around, start a program, run the program, index the turret, and then the controller hangs up on the M03.

I've tried G96 S200, G97 S2000, messing with the G50 clamp... nothing. The spindle drive is stuck in the dash state, which I gather is not ready.

I've also played with the door interlock, but haven't chased down the wires to test.

This is my first fanuc machine, but I've ran and programmed 0M controls at my last job.

Any help would be appreciated.

Thanks!
James