[ar_produkt]

Dear all,
Here is our problem/question:

During the company shut down, the system of our Deep Hole drilling machine MEWAG TL Zi-drill 500 CNC, with CNC control BOSCH Typ1 osa M/CC220 M (107007714-207), Masc. NR:2156/98, memory MCZ4NA (1070077592-108) crashed due to the exhausted battery and we

We replaced the battery and now we need:
- Backup parameters
- correspondence of the procedure on how to load the system back.

Can anyone help me who knows how to solve the problem and send us this process in file, so we can put the machine into operation?

Thank you very much for short reply,
Best regards from Slovenia
Andro Razborsek

[John90]

We have the same machine, and what looks like suitable parameter files backed up on floppy. The floppy files read OK.

We are looking for the Typ1 OSA software which runs on the PC controlling the small screen. We lost that OSA software after failure of the wdal2540 2.5" ide 540mb hard drive. If anyone can help me with the OSA software it would be appreciated.