Are the wear offsets immediate, or only used by the controller on the tool change, or rest?
In other words, say you have to fine tune an insert while boring a hole before the finish pass.
Can you feed hold the machine, use the jog away, measure the hole, then adjust wear offset, then continue, or do you have to reset, then start the program at the beginning of the boring cycle?
On my TL1, I can do run from here, and it will reload the offsets and go to where I left off. On the new ST15, run from here has been removed, you only have Joq Away Return, but I'm unsure if that will read any changes on the offset or wear tables.