Hey guys we;ve built a 9x5 plasma table and have everything but THC working , I have hooked up Arc OK,UP and Down from Plasmasense to AXBB into Port 2 into positive terminals each signal wire and common is jumpered from common on Plasmasens to negative pins of each signal wire, I have set up correct pins in UCCNC but when I run test signal UCCNC doesn't seem to be getting any signal from it, looked through all manuals and search the forum but couldn't find usable info.
Can you guys give me any new ideas on what to try?
Results 1 to 2 of 2
-
04-28-2023, 05:08 AM #1
- Join Date
- Apr 2023
- Posts
- 1
Plasmasens THC + AXBB-E not liking each other
-
04-28-2023, 07:31 AM #2
Member
- Join Date
- Aug 2018
- Posts
- 20
Re: Plasmasens THC + AXBB-E not liking each other
I am working with him on this machine and basically this is the setup we tried as well as pulling -24V into common instead of +24V
Reply With QuoteSimilar Threads
-
my AXBB-E and UCSB are on the way, small annoyance is anyone using axbb with mach3?
By curiosity22 in forum Australia, New Zealand Club HouseReplies: 11Last Post: 05-17-2019, 03:50 AM -
USB THC config missing THC box
By rbmgf7 in forum SmoothStepper Motion ControlReplies: 1Last Post: 01-24-2017, 05:06 PM -
Fanuc 10TEF not liking to fire up. Standby light and button issues.
By blakemachine in forum FanucReplies: 1Last Post: 01-21-2014, 04:30 AM -
mastercam x3 not liking the background colors
By kmachinist2 in forum MastercamReplies: 3Last Post: 07-05-2012, 03:41 PM -
How are you liking the CNCzone Toolbar?
By cncadmin in forum Community Club HouseReplies: 4Last Post: 07-05-2005, 07:54 PM
Tags for this Thread
Posting Permissions
