Hi,
For my project I'm using the following devices:
Stepper Motor: 34HS46-6004D-E1000
Stepper Driver: CL86T v.4.0
Power: 400W 48V 8.3A 115/230V
Breakout board: Pokeys57CNC
I checked 5V to pul/dir terminals of pokeys57 and stepper driver; there is 5 Volts and it change if I change direction of rotation using keyboard.
i'm trying to use motor without encoder, so I setted SW6 switch to "open" mode.
The motor is also locked, so there is voltage at the A+ A- B+ B- coils.
Even if I control movement with keyboard, the motor not run.
Any suggestions?
Can anyone help me?