[pmartin223]

I am new to this hobby and would like to build a simple cnc machine. I would though like to purchase the controller as a kit or completed product so I don't have to build it. Is this possible or am I out in left fielf here.

[sixpence]

I don't know why the address did not post but check out the 'links' you will find the info there . There are
numerous suppliers of the types of kits you need.
hope this helps

[ger21]

A lot of people use the Xylotex stepper drivers on small machines, http://www.xylotex.com .Some also use Geckos, http://www.geckodrive.com . The machine is actually controlled by software, such as TurboCNC, http://www.dakeng.com , or Mach2, http://www.artofcnc.ca

[sendkeys]

http://www.embeddedtronics.com/microstep.html looks like a nice setup ifyour good with electronics

[Just John]

I found an outfit that had 3 steppers and a control card fo $160.00. I'll be danged if I can find it again. Does anyone know the web site?
Thanks

[pfeist]

Could it have been www.stepperworld.com?

Paul F.

[pmartin223]

Thanks, I appreciate the help