[yurirevenge]

z axis excess error fanuc OM

any solution??


my battaries go away and i tying to collect all data from internet

and now i have this error

can u tell me how can i remove it

[yurirevenge]

error 430

and diagnostic 772 = 1

[yurirevenge]

any help??

506 = 16666 Servo error limit Z during move
595 = 100 z Limit of position deviation in the stop state for eadh axis 1000 mean 1 mm

714 = 10000 Pitch error compensation interval for z axis.
737 = 0 distance of second refrense position from the firt one Z
510 = 4789 THE MAIN BACKUP . second reference point with G30

this is some parameter from my machine now

[cncmakers001]

z axis excess error fanuc OM

any solution??


my battaries go away and i tying to collect all data from internet

and now i have this error

can u tell me how can i remove it

Try re-set the reference point.

[yurirevenge]

Try re-set the reference point.

how Fanuc omc

[oetkbyentc]

There may be two excess error alarms. One for moving and one while stopped. Which are you getting and when does it occur?
I.E. If stopped does it occur following a move? If its moving does it occur as soon as the move starts or at the end of the move?

Is the servo stable or is it vibrating?
Does the machine have scales? 16666 seems high for following error.

[yurirevenge]

There may be two excess error alarms. One for moving and one while stopped. Which are you getting and when does it occur?
I.E. If stopped does it occur following a move? If its moving does it occur as soon as the move starts or at the end of the move?

Is the servo stable or is it vibrating?
Does the machine have scales? 16666 seems high for following error.

i getting it when i power on machine
not when moving

102 2
502 20
506 16666
510 4789
520 12000
524 100

all above from the main parameter backup of main machine

---------------------------------
below parameters from net and forums :

595 100
702 2500
706 -560000
714 10000
737 0
745 500000
749 -560000
757 -443978