Lost the hard drive on my mill and had to replace it.
Reloaded mach 3 into the computer and tried out with no movement of the axis.
I see movement on the DRO's on the screen.
First question, do I have to retune the rutex cards. I assumed the cards retained the values
and not in the harddrive.
Next I set the ports and pin for each axis applied and saved.
Went back to configuration and selected motor tuning which kicked me back to main screen.
Would not allow me to change.
The software is a lincense version of mach 3 with my name showing up.
Any ideas on what to do?