[Sprew]

Hello All:
My VMC 10 was dormant, battery depleted, lost parameters. I have recovered everything except this nagging tool number display. Its just the display. Everything else functions properly.
Any ideas?

[machinehop5]

...have you tried SETTO# command?
https://www.fadalcnc.com/media/pdf/Fadal%20Commands.pdf

[Sprew]

...have you tried SETTO# command?
https://www.fadalcnc.com/media/pdf/Fadal%20Commands.pdf

Yes I did try that a few times.
Thanks for the response machinehop5

[rwskinner]

If this isn't fixed yet try the Zero Memory command I believe. You have corrupt memory due to low voltage. It's in the DIAG section of the maintenance manual.

Function 5 = ZERO MEMORY
On the 1400-2 writes zeros to segments 6,8,9,A,B,C,D,E. On the 1400-3
writes zeros to segments 4,5,8,9,A,B,C,D,E.


WARNING:
This will clear all memory SETP, backlash user programs, tool and fixture
information.

[Sprew]

If this isn't fixed yet try the Zero Memory command I believe. You have corrupt memory due to low voltage. It's in the DIAG section of the maintenance manual.

Function 5 = ZERO MEMORY
On the 1400-2 writes zeros to segments 6,8,9,A,B,C,D,E. On the 1400-3
writes zeros to segments 4,5,8,9,A,B,C,D,E.


WARNING:
This will clear all memory SETP, backlash user programs, tool and fixture
information.

OOOPS -
Sometimes we get so busy and moving on to bigger and better problems, we forget to say THANK YOU!

Appreciate the effort and time you took to help with this problem.

Have a great day!

[rwskinner]

Thanks for the feedback.