[Mick40]

I’m planning on building the gantry for a 5ft x5ft Plasma cutter that will allow me to have an actual cutting width of 48 inches. I would like to make the gantry out of aluminum slotted bar like many of you have. Other than cost, what would you suggest? I plan on using flat linier bearings that will be mounted to the frame which will be 2x3 square stock.

Thanks! I ‘m learning a lot reading and I’m almost ready to jump in and start building!

[Degrom]

Welcome to CNCZone. I am sure you will get most of the answers to your questions here.
Just keep asking till you get the answers...

Good luck with the project and keep us up to date with your progress and descoveries!!!

[spydermeister]

I'm working on a design for a plasma table gantry as well...

[Mick40]

Please share!!!