585,737 active members*
4,817 visitors online*
Register for free
Login

Thread: someone wanna write a program?

Results 1 to 3 of 3
  1. 06-07-2004, 01:28 AM #1
    ljoe1969
    ljoe1969 is offline Registered
    Send a message via Yahoo to ljoe1969
    Join Date
    Oct 2003
    Posts
    208

    someone wanna write a program?

    would someone write a program that would take a gcode file from "ace converter" to tell the cut time based on the feed rate in the gcode file?
    Reply With Quote Reply With Quote
  2. 06-07-2004, 01:45 AM #2
    ger21
    ger21 is offline Community Moderator
    Join Date
    Mar 2003
    Posts
    35538
    If someone were to do this, it wouldn't be entirely accurate due to acceleration and deceleration. Depending on your machine, it could be off a lot.
    Gerry

    UCCNC 2017 Screenset
    http://www.thecncwoodworker.com/2017.html

    Mach3 2010 Screenset
    http://www.thecncwoodworker.com/2010.html

    JointCAM - CNC Dovetails & Box Joints
    http://www.g-forcecnc.com/jointcam.html

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
    Reply With Quote Reply With Quote
  3. 06-07-2004, 01:47 AM #3
    ljoe1969
    ljoe1969 is offline Registered
    Send a message via Yahoo to ljoe1969
    Join Date
    Oct 2003
    Posts
    208
    turbo cnc gives acceleration lengths and times. the new program if someone were to write it could take this info into account.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Learning to Program CNC Turning Center
    By Farmer in forum G-Code Programing
    Replies: 13
    Last Post: 09-12-2005, 06:03 AM
  2. parametric programming
    By Karl_T in forum CamSoft Products
    Replies: 21
    Last Post: 05-24-2005, 08:58 PM
  3. How to cut multiple parts (loop a program)
    By Bird_E in forum Mach Software (ArtSoft software)
    Replies: 6
    Last Post: 05-13-2005, 09:16 PM
  4. feeds and speeds program
    By Kees Soeters in forum MetalWork Discussion
    Replies: 3
    Last Post: 05-12-2005, 06:32 PM
  5. A few honest questions
    By HuFlungDung in forum CamSoft Products
    Replies: 8
    Last Post: 06-16-2004, 12:24 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules