I am new to both cad cam software and cnc routing.
When I bought a boat kit in the past it had tabs/bridges in the cuts that were used to hold the part in the plywood. These tabs were 1" every 20" of cutting.
I am looking at cutting kits and was wondering if you left .5mm of material uncut as a carrier it would be easy to punch out or cut out with a utility knife? To little, to much?
What are others doing?
I will put complete sheets of ply board on each side of stack of plywood for shipping and strap with steel straps.
I use Bobcad and Bobnest to create the cuts and don't want to manually put the tabs in if I can keep from it.
Thanks in advance for your ideas.
Sam