585,914 active members*
3,846 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > HURCO > Hurco VM-1 question

Thread: Hurco VM-1 question

Results 1 to 2 of 2
  1. 11-13-2007, 03:23 PM #1
    olslowhand
    olslowhand is offline *Registered User*
    Join Date
    Mar 2005
    Posts
    4

    Hurco VM-1 question

    How to single block thru a program on a VM-1 ?
    Reply With Quote Reply With Quote
  2. 11-14-2007, 02:58 AM #2
    RON MEYER
    RON MEYER is offline Registered
    Join Date
    Jan 2005
    Posts
    49
    PUSH THE MODE KEY THAT SAYS SINGLE. THEN PUSH THE START BUTTON FOR EACH BLOCK. IF YOU ARE IN G CODE, THE CONTROL WILL EXECUTE THE PROGRAM LINE BY LINE. IF YOU ARE IN CONVERSATIONAL, THE CONTROL ACTS A LITTLE DIFFERENTLY. IT EXECUTES BLOCKS WITH SEGMENTS ONE SEGMENT AT A TIME. RON
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Hurco, KM-1
    By dafowfidy in forum Bridgeport / Hardinge Mills
    Replies: 2
    Last Post: 11-08-2008, 12:18 AM
  2. Hurco
    By jawwad in forum HURCO
    Replies: 0
    Last Post: 11-11-2006, 06:54 PM
  3. Hurco KMB1 question
    By jpcuttergrinder in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 13
    Last Post: 11-02-2006, 11:39 PM
  4. Hurco Question
    By daveelc in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 9
    Last Post: 08-24-2006, 05:12 PM
  5. Hurco
    By jlasner@co in forum BobCad-Cam
    Replies: 4
    Last Post: 01-30-2004, 12:45 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules