I am hoping you guys can help me a bit. I have a Sharp 2060TC flat bed lathe with an Anilam 4200T controller. It has a 4 tool automatic changer post on the cross slide and a non programmable tail stock. I have had it about 6 months and my tool holder situation is driving me nuts. I made a couple chuck holders and they are crap. it takes me way to long to setup and get any drill bit straight and level with part zero. I saw a couple of good looking ones noseing around here but not very many. Can you guys post some pictures / drawings of what you are using? I don't have any problem making something, I just want it to look decent and work well. I does not have to be a chuck holder, collet is fine, or just a straight shank clamp. Anything is better than I have now, so any help is appreciated.