Could someone please post a couple of simple lathe programs in Fanuc 10T.
I have been programming a Tsugami Mercury with a 6T for years and I now have another lathe to use only it has a 10TF. I don't care to learn the convesational side of it but hope to be able to program it with G code.
I have been using G50 like a G92 with the tool X and Y position at the beginning of the program and always send the tool back to this position before a tool change and then on the next tool G50 again and so on.
This is the way I was shown to program but believe there may be a better way by using the offsets to load my tool home position in and then a G28 at the end of the program? On my new lathe G50 is not for tool presets but for max speed.
Any help would be greatly appreciated.
Thank you,
Keith