[joesimmers]

I desperatly need the bobcad (version 21) post processor for a haas vf2 that was revised on jan. 2007. The only one I can find on their website is the older one.

I tryed to call all day and never heard back from them.

I know this is available because I used to have it.

Thanks for any help, Joe

[pointcloud]

http://cadcamtrainer.com/forums/index.php try here?

[bluechip69]

That's a great website. Sorin is a standup guy. Bobcad should help you out but getting ahold of them is a problem sometimes. Good luck. Curtis.

[pointcloud]

I never had a problem getting in touch with them, BUT I always have troubles getting RID of the BCC sales staff?

[MikeTheG]

The Haas post that is on the website is the latest post . We had to create 1 haas VF post that worked and remove all the older versions. They should have been done this way in the past so there was no confusion on which to use . This post has been verifyed to work . And has not had any trouble . If you need the Haas post that was Labeled 1-15-07 Please email me at [email protected] and I will contact you on were to download from.

[joesimmers]

Thanks for the help, I discovered after finally getting ahold of tech support this morning that the reason the processor was not work was because of the way I loaded the post.

You need to save it to your computer first, then run it.

If you hit "run" as you download the post will load into bobcad with errors.

Would be nice if they mention this in their download section.

Joe

[pointcloud]

Actually most people Dload it to a folder in case they crash the computer.... That way you will not loose the processor? If you have made changes to the processor please do youself a favor and back it up in another location and call it the modified one....