585,712 active members*
4,191 visitors online*
Register for free
Login

Thread: Yasnac 3000g Startup problem

Results 1 to 2 of 2
  1. 12-16-2007, 01:44 AM #1
    BigBobH
    BigBobH is offline Registered
    Join Date
    Nov 2006
    Posts
    9

    Cool Yasnac 3000g Startup problem

    I recently obtained a Matsuura MC500V Mini Master fitted with Yasnac 3000G controls. The servos won't start and error 31 is reported. It appears that the circuits are wrong/incomplete. I think the unit was updated with a new SVM contactor NCM contactor from Matsuura and an additional relay board fitted. My guess is that these relays somehow link to SVM to prevent the servos coming on if there is an emergency stop situation or an external device is not ready. The problem is that without circuitry for this area it's a bit hard to track down the fault. Help Please. The input and output diagnostic bits all look OK. Also need a circuit for the tape reader interface if available.
    Regards BigBobH
    Reply With Quote Reply With Quote
  2. 01-10-2011, 10:54 PM #2
    chuck767
    chuck767 is offline Junior Member
    Join Date
    Jan 2011
    Posts
    129
    bob, did you get the circuit for the tape reader interface? I could use it too.

    regards,

    chuck

    [email protected]
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Yasnac i80, Rs232 problem
    By dewcnc in forum DNC Problems and Solutions
    Replies: 8
    Last Post: 02-18-2011, 07:03 AM
  2. Homing problem with a Hitachi HT-20 Lathe, Yasnac
    By Stoney372 in forum DNC Problems and Solutions
    Replies: 0
    Last Post: 10-02-2007, 01:39 PM
  3. HAAS VF1 Startup Problem
    By rkdygert in forum Haas Mills
    Replies: 8
    Last Post: 07-25-2007, 12:59 AM
  4. Startup Problem
    By StormWerkz in forum Fadal
    Replies: 14
    Last Post: 03-07-2007, 04:57 AM
  5. Hurco BMC 20 startup problem
    By tirebiter in forum DNC Problems and Solutions
    Replies: 3
    Last Post: 11-08-2006, 11:50 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules