Hello,
I am finding that my tools are cutting about .0004 of an inch too low in the Z-axis consistantly.
I want to modify the current setting by this number and have found some ways of POSSIBLY doing it.
It my blum manual, they talk of a file called BLUM_000.TAP in a directory PLC:\BLUM\. I can't see this on our controller.
It says that line 32 in this file is for putting in an offset.
A. Is this how I should tweak my setting?
Note, I also find reference in another place that this number is for
- Temp. displacement value dR ---hmmmm...
thanks in advance.