Powered up system for first time. All 5 volt power from transformer and usb working fine. Hooked up drives as per instructions regarding setting com to 5 volts on a C1 board from CNC4PC. Tested drives with self test and they work. My home and limit signals work, as the leds go on and off when I activate these switches. I get no power (leds do not light ever) from my outputs. I am using Mach3 software and have verified my parallel port. I have the X,Y and Z enabled and on low active, but I get nothing when I try to tune the motors. When I power up the system I get a thump on each motor, like locking into place. Can anybody offer any help?
Thread: No Output Signal
Results 1 to 2 of 2
-
12-26-2007, 09:10 PM #1
Registered
- Join Date
- Oct 2005
- Posts
- 29
No Output Signal
-
01-27-2008, 09:57 PM #2
Registered
- Join Date
- Jan 2006
- Posts
- 51
Try switching from low active to normal.
Reply With QuoteSimilar Threads
-
code 86 dr signal off
By CBNDude in forum Mazak, Mitsubishi, MazatrolReplies: 14Last Post: 05-24-2022, 07:06 AM -
end of bar signal
By positiverake1 in forum Daewoo/DoosanReplies: 4Last Post: 08-25-2007, 01:34 AM -
Diag: Output Signal: Enable 1 help...
By Flatline's Up! in forum Syil ProductsReplies: 11Last Post: 04-06-2007, 08:11 AM -
Getting analog signal from pc
By roni21702 in forum Computers / Desktops / NetworkingReplies: 1Last Post: 06-15-2006, 07:34 PM -
Using the err signal
By FrankdB in forum Servo DrivesReplies: 1Last Post: 03-31-2005, 01:10 AM
Posting Permissions
