Hi All...

I just discovered the CNCzone and it is great... I have a CNC5 that has had the electronics poop out... Or at least I think so. The tape drive had a problem, so at the suggestion of a gentlemen on the Yahoo users group, I just un plugged the drive and entered a short program by hand. It worked as fine... After not using the lathe for a number of months, I tried it again and now it won't work at all... The little 1 amp fuse on the power supply pops as soon as I turn on the power... Oh well, time for a retrofit I suppose...

Do any of you gentlemen have any suggestions for an idiot proof, bolt on, 'plug-n-play' retrofit system? Or how about a website that may offer such a system?

I would like to get the lathe working again...

Regards
and Happy New Year to you all...

Bob Emott
[email protected]