[Trail Logic]

I am about to buy a small shop machine and am trying to put all the info together. Do I need to have an exhaust/vent system and if so what CFM should I be looking at. For my shop a down draft would be best, if that matters.

Thanks in advance!

Chris

[Weldtutor]

Do I need to have an exhaust/vent system and if so what CFM should I be looking at. For my shop a down draft would be best,

Thanks in advance!

Chris

Hi Chris,
Welcome to CNC Zone! :wave:

Click this link
post #229 for some help with an answer to your question for exhaust requirements.

[sstec]

Chris,
Yes you will need to vent or else your shop will have a very nice coat of fine metal dust every where. Plus you will be breathing it in as well.
Just remember to make up what ever air you pull out.
I have a 1000 cfm fan on my table using a 14" duct to get it out.
Since your just down the road from me.....
I use a swamp cooler from about April - June to help make up air and cool down my shop but it is hard on equipment.
I know of a guy in AJ who had his sitting outside for awhile... Fenced off and under a carport but the sun took its toll on it.
sstec