Hi,
I cannot acces to www.aliencnc.com
Could some one post the datasheet of ths 4 axis 1/8 microstepping driver octostep ver 1.0 ?
Thank you.
Hi,
I cannot acces to www.aliencnc.com
Could some one post the datasheet of ths 4 axis 1/8 microstepping driver octostep ver 1.0 ?
Thank you.
I have a 3-axis aliencnc driver board. Their website appears to be shut down. I found that Stepmaster has a similar data sheet and installation instructions to the aliencnc datasheet I printed out. Much of the text is identical. The Stepmaster board is adjustable for full, 1/2, 1/4 & 1/8 microstepping, while my octostep board is not. Try
http://www.stepmasternc.com/stepmasternc_009.htm
I read on another site that the aliencnc was made by stepmaster. Good luck!
Thank you for your answer
Thank you