Hi, I have a XJ-3030 desktop,with NC Studio control software,i have had a bit of trouble with it,but that problem was fixed a couple of weeks ago,and it has been running fine.
Today i was doing a bit of engraving when the spindle stopped,a message on the LCD display says E.009,When i press the program reset button and restart the machine,it goes fine for a few mins and then the spindle clicks off again and the E.009 message comes again.
I am engraving on MDF and only at 0.5mm so no strain on the spindle,i take it that E.009 is an error message.Any ideas?
Thanks
Mike