little problem with mach or something else?
ok i got my new c10 board from arturo today hooked up everything and i
have controle so if i go into mach3 and in mdi i enter g0x10 it goes in
fast mode to 10 and if then i type gox2 it goes to x2 but.... then as
soon as it hits x2 or any negative value to the last one it starts
slowly to turn the opposite way so just for the sake of example if i go
g0x10 it goes to 10
g0x2 it goes back to 2 and then start to crawll foward but the dro stay
at 2
same goes if i go
g0x5 goes to 5
g0x10 goes to 10
g0x2 it goes back to 2 and then start to crawll foward but the dro stay
at 2
The opinions expressed in this post are my own. -Les opinions exprimé dans ce messages sont les mienne