i am new to mach 3 i am not sure if something is wrong or not.when in a wizard i tab out for the jog control and there is just a blank space there .is the jog feaature disbled when in the wizards or do i have problems.
i am new to mach 3 i am not sure if something is wrong or not.when in a wizard i tab out for the jog control and there is just a blank space there .is the jog feaature disbled when in the wizards or do i have problems.
I think it's disabled. Same thing here.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
thanks at least i am ok for now lol
It is not actually disabled, its simply not filled in. The Jog screen is actually screen 50, the tab key is just a shortcut to displaying it. A wizard writer has the option of using whatever screens he wants, I dont know of any that use screen 50.
Since most wizards are used to create Gcode, but not to run it, there really is little use for a jog screen. One exception is my CopyCat which is actually an interactive wizard that lets you jog around a part and pick up coordinates, it then generates a Gcode file to make that part. I dint implement screen 50, it never occurred to me until I read this note.
ron ginger