[bigeye3107]

Hi,

I don't understand which is the procedure to install pluto-step in emc2. The examples of emc2 with pluto-servo functions, but I want to use pluto-step. And I don't understand the procedure to include pluto-step in emc2.
Can somebody explain me the procedure?

Thanks,

Stephane

[samco]

if you look in the configs/stepper/ there is a pluto ini and hal file.

http://cvs.linuxcnc.org/cgi-bin/cvsw...nfigs/stepper/

sam

[samco]

and

http://www.linuxcnc.org/docs/2.2/htm...to_step.9.html

make sure to take note of 'speedrange' you need to set it for what range will work with your machine. The limited space in the pluto required this trade-off

you can read a bit about the history of it here
http://axis.unpythonic.net/01183862490
http://axis.unpythonic.net/01185276001

sam

[bigeye3107]

Thank you very much sam !

I am a newbie with emc2. And it's not very easy at the beginning...

Yes, I read the limitations of the pluto-step. But I think that must go with my machine.

Thanks again