[foolwelding]

Hello all, i am building a 5x10 dropside table and was wondering how much of a bow max + or - [1/16] ? in or out is allowed per side,the print from dynatorch dosn't say. thanx for your time

[totalfab06]

You need to keep the drive side as "true" as possable. The slave side is a little more forgiving.

[cstroke]

I know what you mean..

I kept mine within 1/16th
I think you can be out a little further than that but shoot for 1/32 and settle for 1/16th. I checked out dynatorchs tables when i was down for school and i'd say theirs are out a little more than 1/16th. so thats what i used as a guide line..
when mounting your gears make them as true as you can you can almost get those perfect.. this will save you troubles later. good luck