(chair)Im trying to find out why when I save back a program to a laptop I get an extra line that does not have code on it. I dont have any problems with the other machines so the DNC software Im using must be set up just fine. does someone know if its a setting that Im not able to find or get to ? Its a O-M fanuc control. program looks something like this.
G0X0.0Y0.0
Z0.0
G1X0.0Y0.0F15.0
G0Z2.0
Thread: spaces between gcode O-M control
Results 1 to 3 of 3
-
02-17-2008, 11:42 PM #1
Registered
- Join Date
- Dec 2007
- Posts
- 8
spaces between gcode O-M control
-
02-18-2008, 12:10 AM #2
Registered
- Join Date
- Jan 2008
- Posts
- 136
most likely is an additional line feed (LF) generated by the control, there may be a setting in the data in/out section of the manual to help. also, the laptop could be generating the additional LF, check the RS232 settings.
-
02-18-2008, 02:37 AM #3
Gold Member
- Join Date
- Mar 2003
- Posts
- 2932
Check parameter #0070 bit #7 (ICR). It's probably a 0, which punches LF + CR + CR. Change it to a 1, which should only punch a LF.
Reply With QuoteSimilar Threads
-
Toolpath Spaces
By Oldbill in forum Uncategorised CAM DiscussionReplies: 1Last Post: 01-21-2008, 04:21 PM -
STL to GCode
By Vixon in forum Uncategorised CAM DiscussionReplies: 2Last Post: 11-11-2007, 05:41 PM -
DIY Router Control/GCode Generation?
By IAD in forum Uncategorised CAM DiscussionReplies: 2Last Post: 02-23-2007, 03:46 AM -
I have a problem with my gcode or my conversion to gcode , everything is tiny?
By NickLatech in forum G-Code ProgramingReplies: 0Last Post: 03-10-2005, 07:46 PM -
gcode to gcode converter
By july_favre in forum Uncategorised CAM DiscussionReplies: 4Last Post: 05-25-2004, 12:51 AM
Posting Permissions
