[racefast]

I created a wire frame and it wont planer i have been trying to figure it out for two days now and its beyond me I called bob cad support on demand friday but they never got back to me until i called them again today monday so i thought i would look here for help

[COMMAND JOHN]

It looks like a bad chain.


John

[The One]

the problem is with the geometry. There are overlaps where the radius meets the angled lines of the protrusion in the bottom right hand corner. If you clean them up and redraw the radius it works fine. I have attached the part file.

Regards

[racefast]

i knew their was a problem somewhere but i dont understand how it happend i used point conect to join lines and fillet to make the curves and i searched for the mistake zoomed in as much as i could and can never find it is their an easy way to locate something like that

[The One]

I like to use the Chain Select method to find these errors.

Just enter into selection mode.
Holding the Shift Key down click on an entity.
If the entire chain selects, de-select it and try another entity.

If there are any overlaps or gaps you should be able to find them using this method.

Regards