We just purchased a used Sharnoa with a Tiger 4 controller and need to find out what the file extension will be for the NC output. Also, if anyone is currently using Surfcam and has a post for the tiger 4 I would really appreciate a copy!!!
We just purchased a used Sharnoa with a Tiger 4 controller and need to find out what the file extension will be for the NC output. Also, if anyone is currently using Surfcam and has a post for the tiger 4 I would really appreciate a copy!!!
I have a tiger 3 and I have to strip the extension off form any file that I load or run under dnc. Not sure if the tiger 4 is the same, but you can try it. As far as a post, the sharnoa is somewhat generic in g code. I've never used surfcam but the turbocam that I use allows me to configure the output. Line numerlization, limits on G2 and G3 to 180 degrees, etc. I open the generated program in notepad and have to remove some extraneous code at the beginning of the program and after that it usually runs well. remember that the file name has the dos limitations.
Andrew Abrams
Marcellus Metalcasters, Inc.
Thanks Andrew,
I'll try that and see if I can get it to work.......I'll keep you posted.
Hi all
We just purchased a used Sharnoa with a Tiger 4 controller and need to find soft for machine computer
Plees help us of you hav it send by email
[email protected]
Thanks