585,767 active members*
4,182 visitors online*
Register for free
Login

Thread: Debug

Results 1 to 3 of 3
  1. 02-23-2008, 07:36 PM #1
    Fido57
    Fido57 is offline Registered
    Join Date
    Feb 2008
    Posts
    9

    Debug

    Hey guys. Just replaced a spindle belt on a Vector drive. Book says to look up encoder value in "Debug". Where the heck is debug? Thanks.
    Reply With Quote Reply With Quote
  2. 02-23-2008, 08:16 PM #2
    pit202
    pit202 is offline Registered
    Join Date
    Jul 2005
    Posts
    340
    debug is a service entry if you`re on help screen type "debug" you`re in debug mode , if you are searching for spindle encoder steps just pg_up / pg_dn in posit screen or currents and commands.
    Reply With Quote Reply With Quote
  3. 02-24-2008, 02:15 PM #3
    serviceman
    serviceman is offline Registered
    Join Date
    Apr 2007
    Posts
    178
    setting 7 off push alarm type debug fo to posit page and page up to pos raw dat in the middle of the screen not labelled turn the spindle you will see the number change
    REYTECH Machine Service Corp. CNC repair NY, NJ
    http://www.reytechmachine.com
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. PICStep V4 (or how to not have to debug your own BOB but use someone elses!)
    By Garfield2 in forum CNC Machine Related Electronics
    Replies: 2
    Last Post: 10-08-2011, 03:43 PM
  2. Help needed to Debug G41 G42 problem
    By Al_The_Man in forum Uncategorised CAM Discussion
    Replies: 4
    Last Post: 07-06-2004, 12:22 AM
  3. Servo motor and encoder. How to debug?
    By ESjaavik in forum Servo Motors / Drives
    Replies: 6
    Last Post: 06-20-2004, 11:37 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules