Hi i need to set the potentiometer and jumpers on my cnc board, but i have lost the instructions could anybody explain how i do this.
I am using the 3 axis board
and the 8wire 1.85Nm from motion control products.
Thanks
David
Hi i need to set the potentiometer and jumpers on my cnc board, but i have lost the instructions could anybody explain how i do this.
I am using the 3 axis board
and the 8wire 1.85Nm from motion control products.
Thanks
David
Hi, David,
There are different settings for different boards. What board and Rev, (revision), number, do you have? Also, it would help to know about how old it is. Given that info, I've probably got the instruction sheets that has the info you need.
All the best
MB
www.mikebeck.org
Sorry, its the 3axis hobbycnc pro rev 1.
Thanks
David
Dave,
If you have a first-run board, the info is printed right on it. If current run, after first of the year, it's not. I'll type it all out for you.
MB
www.mikebeck.org
Hey thanks, i did some digging around and found instructions, Thanks for your help.
David