Don, is it possible to import other fonts into Excalibur. If so, how do I do it. I would like to import a font called Serpentine.
Greig
Don, is it possible to import other fonts into Excalibur. If so, how do I do it. I would like to import a font called Serpentine.
Greig
Greig,
Excalibur uses any True Type font found on your PC provided it is located where all your windows fonts are registered. Put your font in the Windows Font folder and you should be able to use it.
Don
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks Don, I'll check it out
Don, with engraving text, it always seems to convert text to curves with an outline around the text. Is that due to the font I use.
Sometimes I want to just have single line text. How do I achieve this. Is it a font or another command I have to use.
Thanks in advance
Greig
Motorcycle Performance Engineering
All true type fonts are bounded fonts. They are made from closed bondaries. The Excalibur Default font is an internal font that is single stroke...you can use this but its not real pretty.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I think Merlin is right. Virtual Gibbs created their own font for this reason, called Moorpark or something like that.
'Rekd
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)