i have been running my Taig mill form a few months off of the older board design. I'm only running at 12 volts using 1/4 stepping and notice very little torque. If I was to raise my voltage to 24v what do I need to be cautious about?
i have been running my Taig mill form a few months off of the older board design. I'm only running at 12 volts using 1/4 stepping and notice very little torque. If I was to raise my voltage to 24v what do I need to be cautious about?
There shouldn't be a problem.
Phil, Still too many interests, too many projects, and not enough time!!!!!!!!
Vist my websites - http://pminmo.com & http://millpcbs.com