I'm looking for an entry priced Router with a cutting area of 12x24. I want to cut 1/8" aluminum and 1/4" polycarbonate with it. I had looked at the Rockcliff but I'm a total newb to routers and not sure about building one especially for cutting aluminum.

So I started shopping ebay and found these two tables.

This one is just the table and would need the motors and drivers.

http://cgi.ebay.com/ws/eBayISAPI.dll...MEWA:IT&ih=020

This one is complete.

http://cgi.ebay.com/ws/eBayISAPI.dll...m=250228627875
&ssPageName=STRK:MEWA:IT&ih=015

Any advice would be great.