Hi!
Where can i buy board that generates +/-10Volt signal from step/direstion?
Like Pixie-P100!
Hi!
Where can i buy board that generates +/-10Volt signal from step/direstion?
Like Pixie-P100!
www.cnc4pc.com > Speed control board
Juka
Do you want this as a servo drive to connect to an industrial type servo amp ?
I am doing something similiar, but converting a PWM and Dir drive to +/- 10V (DSPIC).
It is a work in progress and I am building the standard amp first then adding the +/- 10V
Here is a schematic for the PWM/Dir to +/- 10V if it helps...
Russell.
Fine
But i would like to make it a litle diferent.
This is a single +/-10 VDC but how to make it diferential, to have two outputs?
One for 0-10DVD and second -10 - 0 VDC .
Where should i change this circuit?
Do you mean something like this ?
You will lose 0.6v across the diode and you should use fast recovery diodes.
Russell.