Hi, We have 2 fadal machines, both 1994 models, a 15xt and vmc10. The spindles i'm assuming are both 10K grease packed non-locking draw bar, also there is no high low belt adjustment, just a 1:1 pulley arrangement, based on the depth of the belleville spring pocket is 4.25 deep. Fadalcnc.com says the 10ks are the only ones with that depth. In the setp menu, the rpm is set at 3750 with a rpm factor of 10 for the 15xt and 6 for the vmc 10. I haven't tested the 15xt yet, but on the vmc 10 the rpm won't let me go above 3750. Is there any way to change this? And why would they have set it up like this?